Ref: REFLEX/SCANFLEX MANUAL
EDITION 1: JULY ’97 33
Number Store
Pr.95 Serial Number (Viewable only)
This parameter displays the serial number of the Reflex unit.
Pr.96 Security Code Store (D=15.02)
A new security code can be entered at this parameter, but after entry it is scrambled.
Refer to Hycontrol if you forget your security code and quote the number displayed
here.
Resets
Pr.97 Relay Hours/Starts Totaliser Reset (D= '====')
The totalisers are cleared by entering:
Pr.97 and 'DSP' to show '===='
Press CE to clear the screen
Press Enter to request 'COdE'
Enter 9753 *
Press Enter to show 'TRES' followed by '===='
The relay hours/starts will now read 0
Pr.99 Return to Factory Default
Press 'MODE' to display 'PROG'
'1' immediately to display 'Pr.01' or previous Pr. number.
'99' to display Pr.99
'DSP' to move cursor under '===='
'CE' to clear the display
'ENT' to display 'COdE' requesting the security code* (see note)
'9753'&'ENT' to display 'PRES' followed by 'TRES', and then to display 'Pr.99.
The new programme can now be entered.
REMEMBER:- FACTORY DEFAULT IS SINGLE POINT REFLEX MODE WITH
RXM19 TRANSDUCER FAMILY.
NOTE * Enter your own security code number if you have changed it from
factory setting of 9753.
To Next Page
Loading...