Pg 2.18 H1822
OPTIONAL BUNDLING CONTROLS
Both the front vise bundling and the shuttle vise bundling can be operated independantly. Both of the bundling
actions can be controlled independantly in relation to the close time of the vise jaws or turned off completely.
To turn the bundling on, turn the ball valve
handle for each of the cylinders (shown in the
photos) so that they are in line with the cylinders.
The opening and closing speed of the
bundling arms can be controlled with the flow
control valves located on the cylinders (shown in
the photos). The bundling can be set to close and
open before the vise jaws move, at the same time
or after the vise jaws move. This is controlled by
turning the small knob at the top or bottom of
each cylinder. The knob at the top of the
cylinders control the closing speed and the knob
at the bottom of the cylinders control the opening
speed.
Front vise
bundling on /
off valve in the
OFF position.
The front bundling on / off
valve is found below the head
at the idler end.
Bundling close
control.
Bundling open
control.
Shuttle vise
bundling on / off
valve in the OFF
position.
Shuttle bundling and front
bundling vises are found
between the head and
shuttle.
To Next Page
