3.14
MACHINE ALARMS
AL1: Emergency: one or more errors occurred:
AL6: Emergency push button or emergency unit engaged:
these alarms are usually displayed at startup, when emergency push button is pressed or safety relay activated.
AL12: Safety blade cover open:
blade guard is opened.
AL16: Forward software limit switch above start position:
this alarm is displayed usually in Manual mode when starting a cut with the head not engaging upper limit switch.
AL21: Out of stock:
this alarm is displayed when the machine runs out of material.
WARNINGS
WR8: Check cut start conditions:
this alarm is displayed when pieces the required are equal to the pieces cut in Automatic Mode
WR13: Jog without homing:
attempt to move the shuttle in Manual Mode without homing shuttle.
WR15: End of cuts:
all pieces to be cut are completed in job mode.
WR16: End of queue:
all jobs in queue are completed.
F1
F2
F3
F4
F5
F6
F7
F8
Events
Details
Clear
Events
Plc
Waminqs
8 WR8: CHECK CUT START CONDITIONS: NO ALARMS
Previous
Next
+
-
To Next Page
Loading...
