1.2 The Hydrion10 Program
The Hydrion10 program is compatible with all PC’s running Windows 95, 98 or (recommended) 2000 / XP. It is not
recommended to run the software on Vista.
It is also not recommended to run the software on dual cores, and if the processor supports hyperthreading;
Hyperthreading should be disabled in the BIOS (refer to your mainboard/pc’s manual for instructions on how to disable
hyperthreading.
The program converts the raw measurement data into accurate results, by simultaneously correcting for: temperature, pH,
total ionic strength and other interactions that influence the measurements. The user is also kept informed about the
actual condition of the sensors and possible exceeding of measuring ranges. Additionally, the Hydrion10 program
performs calibrations and processes data before printing. This leads to highly accurate and reliable results.
Certain variables can be changed via the control panel. However, these settings are only accessible by authorized
personnel with the proper password (i.e. service engineer).
Sensor-unit
Computer
Suitcase
AC-
To Next Page
Loading...
Need help?
General