How to fix Hydrofarm Autopilot PX2 when it does not show temperature after connecting with temperature probe?
If your Hydrofarm Controller does not show the temperature after connecting the temperature probe, try reconnecting the temperature probe.
General| Type | Environmental Controller |
|---|---|
| Amperage | 15A |
| Power Consumption | 1800W |
| Number of Outlets | 2 |
| Control Outputs | 2 |
| Display | LCD |
| Timer Function | Yes |
| Temperature Range | 32°F to 122°F (0°C to 50°C) |
| Voltage | 120V |
Independent zone control, spectral optimization, power saving, and advanced features like dimming.
Two sensors provide data for auto-dimming and high-temperature shutdown.
Shielded cables for reliability, eliminates traditional contactors, reduces infrastructure cost.
Lists all items included in the Autopilot PX2 controller package.
Details voltage, frequency, and control capacity for HID and LED fixtures.
Securely mount the PX2 controller to a wall using provided screws and holes.
Connect the power adapter and attach temperature/signal probes to the bottom panel.
Route probe cables neatly to the ceiling, ideally suspending them.
Shield probes from direct light to prevent inaccurate readings and premature dimming.
Configure zones for controlling up to 50 LED fixtures each.
Configure zones for controlling up to 256 HID fixtures each.
Set Zone A for LEDs and Zone B for HIDs.
Configure units (temp, power), time format, time, and date for the controller.
Cycle through Zone A/B Setup and Output Schedule, and System Setting.
Set Type, Power, R/S, Dim, Stop, and Delay for Zone A.
All settings must be saved for the controller to function properly.
Repeat the setup process for Zone B.
Schedule up to six output levels (wattage/percentage) for the light cycle.
Save the programmed schedule for Zone A and repeat for Zone B.
Refer to pages 8-23 for detailed cable guides on various lighting configurations.
Meaning of controller LEDs (A-G) for status, protection, and signal output.
Solutions for problems like screen errors, fixture control issues, and temperature probe detection.
Connect PHOTOBIO fixtures using the PHOTO-LOC 0-10V cable kit.
Identifies cable ends (Female, Male) and T Connector for LED fixtures.
Connects Phantom HID fixtures using RJ data link and RJ12 T-connectors.
Legend for HID connections: RJ Data Link, RJ12 T-Connector, RJ12 to USB.
Connects Core 2.0 fixtures using IP rated data link and Wieland harness.
Legend for Core 2.0 connections: Data Link, Wieland Harness, Junction Box, Input/Output.
Connects LED and CMH fixtures using the PHOTO-LOC 0-10V cable kit.
Legends for LED (PHOTO-LOC) and HID (RJ12) connections in mixed setups.
Connects LED and HPS fixtures using the PHOTO-LOC 0-10V cable kit.
Legends for LED (PHOTO-LOC) and HID (RJ12) connections in mixed setups.
Connects dual zone HPS fixtures using RJ data link and RJ12 T-connectors.
Legend for HID connections: Data Link, RJ12 T-Conn, RJ12 to USB.
Connects HPS and CMH fixtures using RJ data link and RJ12 T-connectors.
Legend for HID connections: Data Link, RJ12 T-Conn, RJ12 to USB.
Connects HPS and MH fixtures using RJ data link and RJ12 T-connectors.
Legend for HID connections: Data Link, RJ12 T-Conn, RJ12 to USB.
Covers defects for 3 years; excludes misuse, abuse, or failure to follow instructions.
Liability limited to replacement cost; excludes consequential or incidental damages.
Return product to place of purchase with receipt for repair or replacement.
To Next Page
