Changing the Carbon/KDF Pre-Filter
Changing the KDF
Pre-Filter is very easy.
First, depressurize your
system by shutting off
the water source to your
micRO75 unit. Next, re-
move the elbow fitting as
shown, by pushing in the
grey collet and removing
the elbow. Unscrew cap
with the filter attached.
The pre-filter then simply
unscrews from the cap, and
then the new filter screws
right back in. It is important
to make sure the rubber “O”
ring is seated at the bottom
of the threaded stem. When
installing the new filter, be
careful not to over-tighten.
Only a snug hand-tighten-
ing in needed to make a
leak-proof seal
.
Seated rubber “O” ring.
Do not use with water that is microbiologically unsafe or of unknown qual-
ity without adequate disinfection before or after the system.
Limited Liability: HydroLogic Purification Systems makes no warranties of any kind, expressed or im-
plied, statutory or otherwise and expressly disclaims all warranties of every kind, concerning the product
including, without limitation, warranties of merchantability and fitness for no particular purpose, except
that this product should be capable of performing as described in this products’ data sheet. HydroLogic
Purification Systems obligation shall limited solely to the refund of the purchase price or replacement of the
product proven defective, is HydroLogic Purification System’s sole discretion. Determination of suitability of
this product for uses and applications contemplated by Buyer shall be the sole responsibility of Buyer. Use
of this product constitutes Buyers acceptance of this Limited Liability.
6
To Next Page
Loading...
