Why is the PRODUCT (purified water) flow low in my HydroLogic Water System?
Low PRODUCT (purified water) flow can occur due to several reasons: * Cold feedwater: Consult the temperature correction sheet for guidance. * Low operating pressure: Refer to the instructions addressing low inlet pressure. * Fouled or scaled membrane: You may need to replace the membranes. * Plugged pre-filter: Try changing the pre-filter.
What causes poor PRODUCT (purified water) quality in a HydroLogic Water System?
Poor PRODUCT (purified water) quality in your HydroLogic Water System may stem from: * Low operating pressure: Refer to the section on addressing low inlet pressure. * Damaged or oxidized membrane: In this case, replace the membranes.
General| Brand | HydroLogic |
|---|---|
| Model | Hydroid |
| Category | Water Filtration Systems |
| Language | English |
Emphasizes reading the manual and maintaining an operating log for warranty.
Critical warnings about water quality, electrical safety, chlorine, and temperature.
Details the microprocessor controller, its features, and display.
Details the pump, its pressure gauge, and related components.
Instructions for connecting feed and product water lines.
Outlines electrical specifications and safety precautions.
Lists the optimal and maximum operating limits for the system.
Instructions on how to prepare and purge the system before operation.
Step-by-step guide for connecting system tubing and flushing the pre-filter.
Connects tubing and activates the system purge feature.
Details purging process, leak inspection, and membrane flushing.
Details membrane type, operating limits, pH range, and chlorine tolerance.
Addresses issues like low inlet pressure, low product flow, and system inoperability.
Troubleshoots problems with the inlet valve and RO pump not operating.
Details the function of the LED display, status LEDs, and control buttons.
Explains specific fault conditions and their handling.
To Next Page
