Hydropool Self Clean 970 Titanium - Page 25

25
KEYPAD SETTINGS
In this secon you can change the
temperature unit and language. Use the
arrow keys and move to the seng that you
would like to change. Use the Light key to
choose and the arrow keys to modify
For the temperature seng you have a choice
between Fahrenheit or Celsius.
For the language seng you have a choice
between English and French.
ELECTRICAL CONFIGURATION
Please do not make changes in this secon
unless you are a qualified electrician.
ABOUT
This secon shows informaon about the
keypad soware number and the revision
numbers of the different components of your
system.
PURGE CYCLES
The purge cycles are programmed to begin at the start of each filter cycle. Pump 2 acvates
for 1 minute, shuts off and then Pump 1 acvates for 1 minute then shuts off.
SMART WINTER MODE
Smart Winter Mode protects your system from the cold by turning the pumps on several mes
a day to prevent water from freezing in the pipes. The Smart Winter Mode indicator turns on
when in this mode of operaon. If the temperature drops to 4
o
C (39
o
F) within the heater
chamber, the system automacally acvates the pump to provide freeze protecon. The
pump will operate unl the temperature reaches 5
o
C (41
o
F) before returning to normal system
mode.
COOLING DOWN
Aer heang the spa water to the desired set point, the heater is turned off, but the filtraon
pump remains on for a certain amount of me to ensure adequate cooling of the heang
element in order to prolong the useful life of the heater. “Cooling to XX”F (”C)” message will
appear at the boom of the screen.