47
PROTECTING YOUR CABINET EVERLAST FINISH
Some HYDROPOOL hot tub cabinets are made from Everlast synthetic plastic material. These cabinets utilize a magnetic
latching system to fasten and hold the exterior panels in place. In order to remove a panel for access you need to start at
the lower right hand corner of the panel and disengage the first magnetic latch by pulling the panel forward enough to
allow your hand to get behind the panel. Once you have done that you can run your hand behind the panel to disengage
the other magnetic latches and be able to remove the panel completely.
To reinstall the panel, line the panel up in the opening and lift it in place and the magnetic latches will engage with the
panel so you can shift it place and complete the reinstallation.
HYDROPOOL spa Everlast Synthetic cabinets are made from a unique, non-porous all-weather plastic material and with
proper care will maintain its beauty for many years.
CLEANING
Using hot soapy water and a stiff bristle brush, a soft cloth or sponge will remove surface dirt and grime. Stains can be
removed with a water-based cleaner (E.g. Windex, Pledge, Simple Green, etc.). You can also use a power washer with a
medium/ wide nozzle setting to clean the surface of the product. Cleaning every few months is recommended.
...CAUTION: Do not use cleaners containing aromatic solvents or harsh detergent /chemicals on “Everlast” material.
If dirt and surface contaminants are causing a dirty/brownish tint, an extra step can be taken. Use a 75% bleach and 25%
water mixture and wipe the surfaces down. Allow the mixture to remain on the product for an hour, then rinse thoroughly.
(Be sure to do this in a safe location and protect your eyes, skin, and wear old clothes).
MAINTENANCE
Your HYDROPOOL ‘Everlast’ cabinet is made from a next-generation outdoor premium synthetic material. If the material
is damaged during use (scratched or chipped), it can often be repaired.
Repairing Scratches — Take a very fine grade of steel wool (0000 grade) and “sand” the scratched area in the same di-
rection that the embossing pattern runs. Apply enough pressure to gradually minimize the scratched area. Once the
scratches are reduced, the surface area may appear dull and possibly even lighter in color; however, this will be less no-
ticeable over time and with outdoor exposure. To finish the repair, apply liquid paste such as Finesse-it, furniture polish or
carnauba wax and buff using auto paint repair buffing wheel to a finish.
To Next Page
Loading...
