Hydropool Self Clean 970 Titanium - Page 27

27
2. Installing the spa transmier
If you purchased a spa with in. touch 2 as a standard feature or as an opon, note that the spa
transmier will be pre-installed.
To ensure proper signal transmission, it may be necessary to change the posion of the
transmier once the spa is installed in the yard. The transmier should be located on the side
of the spa facing the house.
The in. touch 2 spa transmier must be installed under the spa skirt, at least 12” (30 cm) away
from any metal component or structure, as close as possible to the house to opmize the
signal strength.
Simply connect the spa transmier into an available CO port of the spa control system (or any
other accessory with a free CO port, such as the in. stream 2 audio amplifier, or the in. clear
water sanizaon system).
3. Pairing the home and spa transmiers
If you bought an in. touch 2 equipped spa or a complete retrofit kit, both transmiers of your
in. touch 2 will be factory pre-paired.