z
Remove lower cover and connect input (LINE) and output (LOAD) wires to
proper terminals as shown above.
z
Drill suitable hole in bottom of controller and connect rainswitch leads to
yellow leads using wire nuts provided and follow Rainswitch manufactures
mounting directions.
z
Note: If no rainswitch is used, switch must be in "OVERRIDE" position for
controller to function.
z
Reinstall lower cover
z
See 1000 / 2000 booklet for programming and operating instructions
* May be used with Mini Clik II, Toro Rainswitch model 850-74, or other normally
closed Rainswitch devices.
Models 2510 2520 2514
Power In 110 VAC 220 VAC 110 VAC
Power Out 110 VAC 220 VAC 24 VAC
Relay Contactor rated up to
2 H.P.
Relay Contactor rated up to
2 H.P.
Built in Transformer
Pa
e 9 of 9
To Previous Page
Loading...
