All Hydrotherm heat pumps are designed for installation by a licensed plumber in accordance
with standards set out in AS/NZS 3500.2 “National Plumbing and Drainage Code Hot Water
Supply Systems - Acceptable Solutions”.
5.1 DELIVERY
11
INSTALLATION INSTRUCTIONS
• Hydrotherm heat pumps must be stored and transported in a near vertical position at all
times with a tilt ratio of no more than 30°. Transporting or storing the unit in a horizontal
position will void warranty.
• The system should always be transported in it’s packaging.
• The weight of the package system is 137kg (118kg unpacked). The system must be
handled by two people at all times to avoid unnecessary strain and damaged.
• Please note the outer casing of the unit is susceptible to denting and damage. Care and
consideration should be taken into account when moving the unit as any marks caused by
inappropriate handling are not deemed as defects and are not covered under warranty.
Important information regarding flammable materials.
• The appliance should not be stored or transported in an area with an ignition source.
• Do no pierce or burn the appliance.
• Be aware that the refrigerant may not cause an odour.
• Compliance with AS/NZS 5601 must be observed while storing the appliance.
• National and state regulations exist for the storage, transportation and handling of
•
or stored together will be determined by the appliance regulations.
To Next Page
Loading...
