Hypercom T7 series - Terminal Access and Software Management

Equipment Information
940114-020 Hypercom Point-of-Sale 1-9
%GGIWWMRKXLI8IVQMREPW&SSX0IZIP
The terminal’s Boot level contains the terminal software application, for example, T7_SMHT.xxx,
as well as other various settings like: dial modes, option settings, hook delay, and printer
settings.
N
OTE: Printer settings reside in the Boot level for terminals with EPROM 2.00 or higher only.
One of the following screens will appear, depending on the EPROM version and the previous
action taken at the terminal’s Application level.
7GVIIR 
7GVIIR 
7GVIIR 
Previous action and EPROM version Terminal display
If the terminal’s Initialization has been deleted
by performing Function 9, 9, Enter, 9, Enter, and
1, Enter at the terminal’s Application level, the
the following message appears on terminals
with EPROMs less than 2.00.
&21),*85(7(50,1$/
25&$//+(/3&2
Previous action and EPROM version Terminal display
If the terminal’s initialization has been deleted
by performing Function 9, 9, Enter, 9, and 1, Enter
at the terminal’s Application level, the following
message appears on terminals with EPROMs
higher than 2.00.
3/($6(,1,7,$/,=(
Previous action Terminal display
If the terminal’s software and initialization have
not been deleted at the terminal’s Application
level, the terminal displays the following
message.
'$7( 7,0(
6:,3(&86720(5&$5'