Hypercom T7 series - Page 25

Chapter 1
1-8 T7 Series Troubleshooting Manual 940114-020
6a If more than one host exists in the terminal, type
the host ID, or 0 for all hosts, and press Enter.
Caution:This action deletes the batch. The batch
is no longer in the terminal once you
perform this function.
The Hypercom terminal can support more than
one financial host. The terminal individually dials
each host for authorization and then settles to
each respectively. This is called Multi-Host.
+267180%(5 
7 Press Cancel to return to the Idle prompt or
proceed with the next Step.
7<3("
75$16$&7,21&203/(7('
8 To delete the initialization, press the key
sequence: 1, Enter.
7<3("

The terminal displays the following message. 7<3("
75$16$&7,21&203/(7('
9 Press Cancel.
If the EPROM version is less than 2.00, the
terminal displays the following message.
&21),*85(7(50,1$/
25&$//+(/3&2
If the EPROM is higher than 2.00, the terminal
displays the following message.
3/($6(,1,7,$/,=(
10 If you are preparing to download the terminal with
a new software application, you must delete the
existing software application which resides at the
terminal’s Boot level. Refer to “Accessing the
Terminal’s Boot Level” on page 1-9
for more
information.
Step Action Terminal display