Hypercom T7 series - Page 28

Equipment Information
940114-020 Hypercom Point-of-Sale 1-11
(IPIXMRKXLI'YVVIR X7SJX[EVI% TTPMGEXMSREXXLI
8IVQMREPW&SSX0IZIP
The terminal’s Boot level contains the terminal software application as well as other various
settings like: dial modes, option bit settings, hook delay, and printer settings.
When preparing to do a new software download, you must delete the current terminal software
application from the terminal’s Boot level.
One of the following screens will appear, depending on the EPROM version and the previous
action taken at the terminal’s Application level.
7GVIIR 
7GVIIR 
Step-by-Step
To delete the current software application at the terminal’s Boot level:
Previous action and EPROM version Terminal display
If the terminal’s Initialization has been deleted
by performing Function 9, 9, Enter, 9, Enter, and
1, Enter at the terminal’s Application level, the
terminal displays the following message on
terminals with EPROMs less than 2.00.
N
OTE: FE means Format Error, indicating you
are in Boot level.
&21),*85(7(50,1$/
25&$//+(/3)(
Previous action and EPROM version Terminal display
If the terminal’s initialization has been deleted
by performing Function 9, 9, Enter, 9, Enter, and
1, Enter at the terminal’s Application level, the
following message appears on terminals with
EPROMs higher than 2.00.
N
OTE: FE means Format Error, indicating you
are in Boot level.
3/($6(,1,7,$/,=(
25&$//+(/3)(
Step Action Terminal display
1 Press the key sequence: Function 9, 8, Enter. 0(5&+$17)81&7,21
