Hypercom T7 series - Page 29

Chapter 1
1-12 T7 Series Troubleshooting Manual 940114-020
'SRJMKYVMRKE8IVQMREPJSVE7SJX[EVI% TTPMGEXMSR
(S[RPSEH
The terminal will need to be configured by performing a Function 2 and entering a Terminal
Identification Number and the INIT and NMS telephone numbers to dial the host for a software
application download.
One of the following screens appear, depending on the terminal’s EPROM version.
7GVIIR 
The terminal performs a self-test and displays the
EPROM version.
7$(350[[[
:$,76(/)7(67
The terminal performs a self-test and displays the
Memory Page status.
0(025<3$*(67$786
22)))))))
The terminal performs a self-test and displays the
EPROM version.
7$(350[[[
:$,76(/)7(67
If the terminal has an EPROM of less than 2.00,
the following message appears.
N
OTE: PE means Program Error, indicating the
terminal has no software.
&21),*85(7(50,1$/
25&$//+(/33(
If the terminal has an EPROM of 2.00 or higher,
the terminal displays the following message.
N
OTE: PE means Program Error, indicating the
terminal has no software.
3/($6(,1,7,$/,=(
25&$//+(/33(
2 The current software application has been
deleted from the terminal’s Boot level and is ready
to be configured to receive a new software
application download. Refer to “Configuring a
Terminal for a Software Application Download” on
page 1-12
.
Step Action Terminal display
EPROM version Terminal display
If the EPROM is less than 2.00, the terminal
displays the following message.
NOTE: PE means Program Error, indicating the
terminal has no software.
&21),*85(7(50,1$/
25&$//+(/33(