Hypertech POWER PROGRAMMER III - Troubleshooting and Service Preparation

3. ATTEMPTING TO PROGRAM A DIFFERENT VEHICLE
• If you attempt to program the computer in another vehicle
without first programming the original vehicle back to stock,
the following screen will appear:
4. CALIBRATION NOT FOUND
• If your vehicle has a factory program that is not recognized by
the programmer, it cannot continue. This screen will appear:
•
Call Hypertech at the provided phone number on the programmer
screen. Please have your vehicle VIN number ready. The Hypertech
technical staff will instruct you what to do.
5. SOMEONE REPROGRAMS YOUR COMPUTER
• If a service facility reprograms your vehicle’s computer with
an update, your Hypertech Power Tuning will be erased.
However, all you need to do is to reconnect the programmer
and press the s arrow.
• If the new vehicle computer calibration is identified by the
programmer, the options in Section 2 will be shown. If the
new vehicle computer calibration can not be identified by the
programmer, this screen will appear:
•
Call Hypertech at the provided phone number on the programmer
screen. Please have your vehicle VIN number ready. The Hypertech
technical staff will instruct you what to do.
20
CODE 91: PROGRAM YOUR VEHICLE BACK TO STOCK BEFORE
PROGRAMMING ANOTHER VEHICLE
CODE 6D:
CAL NOT FOUND
CODE 6D:
CAL NOT FOUND