6. BLANK SCREEN
For 1994 Camaro/Firebird and 1994-1995 Impala SS/
Caprice/Roadmaster:
• If the programmer does not turn on when the s arrow is
pressed, replace the 9-volt battery inside the programmer. To do
this, turn the programmer to the back side and remove the four
(4) screws. Gently pull the two (2) halves of the programmer
apart. Be careful not to stress the ribbon cable that connects the
two (2) halves. Remove the old battery by gently pulling up on
it and replace it with a new one. Put the two (2) halves together
and reinstall the screws. Call Hypertech at 901-382-8888 if this
does not correct the problem.
For all other LT1/LT4 vehicles:
• If the programmer does not turn on when the s arrow is
pressed, make sure that both ends of the cable are fully
inserted. Press the s arrow again. If the programmer still does
not turn on, check for a blown fuse in the vehicle fuse panel
for either the cigarette lighter or the accessory circuit.
Replace with the proper amperage fuse. Call Hypertech at
901-382-8888 if this does not correct the problem.
IF YOU HAVE ANY PROBLEMS OR QUESTIONS,
PLEASE CALL OUR TECHNICAL STAFF AT 901-382-8888
HOURS: 8AM - 5PM Central Time, Monday - Friday
Hypertech, Inc. 3215 Appling Road
Bartlett, TN. 38133-3999
Visit our website at www.hypertech.com
or e-mail us at sales@hypertech.com
21
To Next Page
Loading...
