Torch seTup
2-12 Duramax Retrofit Torch Operator Manual
Install the machine torch consumables
To operate the machine torch, a complete set of consumable parts must be installed: shield, retaining cap, nozzle, electrode,
and swirl ring.
With the power switch in the OFF (O) position, install the machine torch consumables in a manner similar to the hand torch
consumables. Refer to “Install the hand torch consumables” on page 2-4.
WARNING
INSTANT-ON TORCHES
PLASMA ARC CAN CAUSE INJURY AND BURNS
The plasma arc comes on im me di ate ly when the torch is activated. Make sure the power
is OFF before changing the consumables.
Aligning the torch
Mount the machine torch perpendicular to the workpiece in order to get a vertical cut. Use a square to align the torch at 0°
and 90°.
Torch
0°
90°
To Next Page
Loading...
