Launch the software (PlasmaCAM) from the desktop shortcut, or from the start menu
Accept the Windows UAC message to continue
Initialize the torch/software using Machine->Initialize
This sends the torch carrier to the top, left, and raises the Z axis full up
Should be used any time settings are changed to ensure proper communication
between gantry/torch and software.
Shortcut keys are HANDY to learn: Press the shortcut key for the function desired,
then use the mouse to direct to the location needed. More on this as we progress
All this work CAN be done without stock loaded in the bed, but it seems like a better
choice to load the material first, and then walk through these steps to make sure the
cuts will happen as desired on the actual material
Perform an “Initialize” for the greatest bed clearance for loading stock
Largely, place the material anywhere in the bed, bearing in mind that all cuts
should fall between support stanchions. Most people opt to put their material in
the bottom left, closest to the control panel
The PlasmaCAM Software – Getting Started
To Next Page
Loading...
