Need help?Do you have a question about the Hypertherm Powermax 1000 and is the answer not in the manual?
General| Open Circuit Voltage (OCV) | 300 VDC |
|---|---|
| Gas Supply | Clean, dry, oil-free air or nitrogen |
| Cut Capacity (Maximum) | 1 in (25 mm) |
| Pierce Capacity | 1/2" (13 mm) on mild steel |
| Gas Type | Air or Nitrogen |
Essential safety rules, including personal responsibility, potential equipment interference, and operating at your own risk.
Explains the operation of the PlasmaCAM control panel, including power, stop, and movement controls.
Covers launching the software, accepting prompts, and initializing the torch/software for use.
Explains how to link design segments for continuous cutting paths and how to adjust linking settings.
Guides on defining cut paths, setting lead-ins, and establishing the correct cutting order for jobs.
Provides guidelines for checking torch head condition, electrode, and nozzle for optimal performance.
Covers duty cycle, material limits, flatness, ground clamp attachment, and the importance of workpiece grounding.
Details manual Z-axis adjustment, selecting parts, and performing 'dry run' cuts before final shutdown.
To Next Page
