Manually adjust the Z axis to about 1/16(0.0625)”- 1/8(0.1250)” above the stock
Use a penny (0.0598”) to gauge (– it should just drag when sliding between the stock &
the torch tip
Press the Z axis up or down arrow to adjust
For finer adjustments use the dial -- clockwise to raise & counter clockwise to lower
This height control overrides any auto-torch height
Select the parts to cut
Using the click & drag technique OR hold CTRL key & click each line
Notice the parts to be cut are highlighted in green as selected
To initiate the cut, use Machine->Cut
“Dry run” the cuts with the “Cutting” setting on the PlasmaCAM controller OFF
Once finished, turn everything off (including the evacuation fan) & remove the air hose from
the plasma cutter
Clean up, please
Bringing it all Together – Adjust Torch & Stock
Next: Other info
To Next Page
Loading...
