White segments appear if the cut lines are not linked. To select the parts to link:
click, hold, and drag the selection box to fully surround the parts to link
OR hold CTRL key while clicking the links to be added
Once all parts are selected, use Edit->Link Segments (or press “K”) to
link
If they still will not link (still seeing white segments) try:
Zooming (F1 key then click and drag the mouse to select the area) into the area
and then trying the above again
OR use Machine->Settings->Drawing Settings->Link Segments
(shown next slide) to increase the tolerances for the Link Segments and try the above
again
The PlasmaCAM Software – Linking Segments
To Next Page
Loading...
