HyperX Pulsefire Haste Wireless User Manual

Document No. 4P5D#AA.A01
HyperX Pulsefire Haste Wireless
Page 8 of 8
Charging
It is recommended to fully charge your mouse before first use. Battery percentage can be
found within NGENUITY.
The mouse is charged via USB-C, located at the top part of the mouse. While the cable is
attached, the mouse will operate in wired mode.
DPI Presets
There are 4 default DPI presets
400 DPI (red), 800 DPI (blue), 1600 DPI (yellow), 3200 DPI (green).
Up to 5 DPI presets can be stored on the mouse. Customizing and saving DPI settings can be
done with NGENUITY.
HyperX NGENUITY Software
To customize lighting, DPI, polling rate, lift off distance, macro settings, and check battery life,
download the HyperX NGENUITY software at: hyperxgaming.com/ngenuity.
Factory Reset
If you are experiencing any issues with the mouse, you can perform a factory reset. Onboard
memory will be cleared, and all settings will revert to default DPI settings listed above and
lighting effects (Rainbow Cycle).
Hold DPI button + mouse wheel button down for 5 seconds. The mouse wheel will flash red
momentarily and disappear once reset has completed.
Questions or Setup Issues?
Contact the HyperX support team at: hyperxgaming.com/support/

HyperX Pulsefire Haste Wireless Specifications

General

Sensor	Pixart PAW3335
DPI	Up to 16000 DPI
DPI Presets	400 / 800 / 1600 / 3200 DPI
Speed	450 IPS
Acceleration	40G
Wireless Type	2.4 GHz
Battery Life	Up to 100 hours
Buttons	6
Charging Type	USB-C
Weight	61g
Polling Rate	1000 Hz
Cable Length	1.8m
RGB Lighting	Yes
Connectivity	Wireless
Grip Style	Claw, Fingertip, Palm
Switch Type	TTC Golden Micro Dustproof Switch
Switch Durability	80 Million Clicks
Dimensions	124.3mm x 66.8mm x 38.2mm