Repair 1800 SRM 1038
Legend for Figure 1
1. BRAKE HOUSING
COVER CAPSCREW
2. BRAKE HOUSING COVER WASHER
3. BLEEDER SCREW
4. FORCED COOLING
INLET PLUG
5. BRAKE HOUSING COVER PLUG
6. INLET FITTING PLUG
7. BRAKE HOUSING C
OVER
8. AXLE COVER HOUSING WASHER
9. AXLE COVER HOUSING CAPSCREW
10. PISTON SEAL
11. PISTON SEAL SPACER
12. PISTON
13. STATIONARY DISC
14. FRICTION DISC
15. STATIONARY BRAKE HOUSING DISC SPACER
16. BRAKE HOUSING
17. PISTON RETURN
SPRING GUIDE
18. PISTON RETURN SPRING
19. PISTON RETURN SPRING PLUG
20. BRAKE HOUSING P
LUG
21. FACE SEAL ASSEMBLY
22. TEMPERATURE SENSOR BRACKET
CAPSCREW
23. TEMPERATURE SENSOR BRACKET WASHER
24. TEMPERATURE SENSOR BRACKET
25. TEMPERATURE SE
NSOR PLUG
26.FILLANDLEVELPLUG
27. MAGNETIC DRAIN PLUG
28. INLET FITTING PL
UG
29. BRAKE INLET FITTING
30. FORCED COOLING OUTLET PLUG
Repair
REMOVE
Brake Assembly
WARNING
Support the truck with safety stands. Do not
workunderatrucksupportedonlybyjacks.
Completely remove the air pressure from the
tires before removing the wheels from the lift
truck. Air pressure in the tires can cause the
tire and rim parts to explode, causing serious
injury or death.
Always wear saf
ety glasses.
1. Place truck on le
vel surfaces.
2. Lower the mast co
mpletely.
3. Shut down the eng
ine.
4. Place blocks at f
ront and rear of steer tires. See
Figure 2.
5. Raise the drive w
heels.
6. Put blocks under
frame.
1. DRIVE TIRES 2. STEER TIRES
Figure2. PutLiftTruckonBlocks
2
To Next Page
Loading...
