Need help?Do you have a question about the Hyster H50XT and is the answer not in the manual?
General| Model | H50XT |
|---|---|
| Tire Type | Pneumatic |
| Load Capacity | 5000 lbs |
| Category | Forklift |
| Fuel Type | LPG |
| Rated Capacity | 5, 000 lbs |
| Engine Power | 59 hp |
| Mast Type | Triplex |
Steps to safely remove forklift forks from standard carriages.
Steps for correctly installing forklift forks onto the carriage.
Procedures for inspecting forks for damage and verifying tip alignment.
Steps to remove forks from a fork positioner carriage.
Steps to correctly install forks onto a fork positioner carriage.
Procedures for inspecting fork positioner carriage forks for damage and alignment.
Steps to remove the standard carriage from the mast assembly.
Procedures for cleaning and inspecting the standard carriage components.
Steps to correctly install the standard carriage onto the mast.
Steps to remove the integral sideshift carriage from the mast.
Steps to disassemble the integral sideshift carriage.
Procedures for cleaning and inspecting integral sideshift carriage components.
Steps to assemble the integral sideshift cylinder and carriage components.
Steps to install the integral sideshift carriage onto the mast.
Steps to remove the fork positioner carriage.
Steps to disconnect hydraulic hoses from the fork positioner.
To Next Page
