User Manual Debugging
41
d. Select the
Alarm Status
tab, and turn on all switches if a repeater management system (RMS) is
configured. When an alarm is generated, it will be alerted in red font and needs handling.
2. Click Setting, the result will be displayed in the message pane.
Note
To restore the factory settings, click Factory Reset.
6.2.3
Upgrade
PSS allows you to upgrade the main program of the monitor board and the main program and FPGA of the
digital board.
1. In the Upgrade area, click Load.
2. Select the software and click Upgrade. The result will be displayed in the message pane.
To Next Page
