EasyManuals Logo

Hytera HM785 User Manual

Hytera HM785
66 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #14 background imageLoading...
Page #14 background image
8
3. Installation
3.1 Instructions
Before installing the radio in a vehicle, read the following instructions carefully:
Before installation, check the ground polarity and voltage of the vehicle power. The radio must work with a 13.6
V±15% negative ground electrical system.
Before installation, check how long the screws will extend from the bottom surface of the radio. Drill the mounting
hole cautiously to avoid damage to the vehicle wiring and other parts.
Before you install the radio in the mounting bracket, connect the antenna and power cord to the radio. Use the
dedicated antenna and power cord provided by the Company for digital radios.
Install the radio with the mounting bracket supplied by the Company, to avoid accidental radio looseness. The loose
radio may cause bodily injury.
Install the radio in a location where you can reach the front panel conveniently.
Keep sufficient clearance at the back of the radio for wiring.
Use the fuse with the same specification for DC power cord upon replacement.
If any other devices are in the vicinity of the radio, keep the antenna of these devices at least 10 m away from that
of the radio.
3.2 Tools
Electric drill
Phillips screwdriver
T20 torx screwdriver

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hytera HM785 and is the answer not in the manual?

Hytera HM785 Specifications

General IconGeneral
Channel Capacity1024
Operating Voltage13.6 V ± 15%
GPSYes
BluetoothYes
Channel Spacing12.5/20/25 kHz
Operating Temperature-30°C to +60°C
Frequency Stability±0.5 ppm
Antenna Impedance50 Ω
Modulation Limiting±2.5 kHz @ 12.5 kHz; ±4.0 kHz @ 20 kHz; ±5.0 kHz @ 25 kHz
Audio Distortion≤3%
Intermodulation≥65dB
Spurious Response Rejection≥70dB
IP RatingIP54
Frequency RangeUHF: 400-527MHz
Display2.4-inch
Digital ProtocolDMR
FM Hum & Noise≥40dB
Adjacent Channel Power≥60dB
Audio Response+1~-3dB
Conducted & Radiated Emission-36dBm <1GHz; -30dBm >1GHz
Adjacent Channel Selectivity≥60dB
Zone Capacity64 (each with a maximum of 256 channels)
Sensitivity (Analog)0.22 μV (12 dB SINAD)

Related product manuals