Hytera HM785 User Manual

26
6.5 Include Call (Trunking Only)
An include call is a special group call during which another group is invited during the call hang time. An include call
has the same Talk Priority and Clear Down feature as a group call.
The Include Call feature is enabled by your dealer.
For operations of initiating, receiving, or ending an include call, see 6.1 Group Call.
6.6 Phone Call
A phone call is a call made from the radio to a phone through a repeater after the repeater accesses the PSTN/PABX
system through a PSTN/PABX gateway.
6.6.1 Initiating a Phone Call
6.6.1.1 Conventional Mode
Through Contact List
Press the preprogrammed Contact List or Favorite Contact List key, or go to Menu > Contact/Favorite.
Select the phone contact.
Press and hold the PTT key.
Through Manual Dialing
With the phone call dial permission enabled by your dealer, do as follows:
On the home screen, enter the phone ID, and then select DTMF Dial.
Press and hold the PTT key.
The phone ID must be complied with the dialing rules. For details, consult your dealer.
6.6.1.2 Trunking Mode
Through Contact List
1. Press the preprogrammed Favorite Contact List key, or go to Menu > Favorite/Private.
2. Select the PSTN/PABX contact.
3. Press the P5/Answer key on the radio, or press the Answer key or the PTT key on the palm microphone.
Through Manual Dialing
On the home screen, enter the phone ID through the keypad on the palm microphone.
Select PSTN/PABX.
Do either of the following:

Hytera HM785 Specifications

General

Channel Capacity	1024
Operating Voltage	13.6 V ± 15%
GPS	Yes
Bluetooth	Yes
Channel Spacing	12.5/20/25 kHz
Operating Temperature	-30°C to +60°C
Frequency Stability	±0.5 ppm
Antenna Impedance	50 Ω
Modulation Limiting	±2.5 kHz @ 12.5 kHz; ±4.0 kHz @ 20 kHz; ±5.0 kHz @ 25 kHz
Audio Distortion	≤3%
Intermodulation	≥65dB
Spurious Response Rejection	≥70dB
IP Rating	IP54
Frequency Range	UHF: 400-527MHz
Display	2.4-inch
Digital Protocol	DMR
FM Hum & Noise	≥40dB
Adjacent Channel Power	≥60dB
Audio Response	+1~-3dB
Conducted & Radiated Emission	-36dBm ＜1GHz; -30dBm ＞1GHz
Adjacent Channel Selectivity	≥60dB
Zone Capacity	64 (each with a maximum of 256 channels)
Sensitivity (Analog)	0.22 μV (12 dB SINAD)