33
8.1.2 Call Settings
8.1.2.1 Power Level
You can set the TX power level to high or low.
Go to Call Settings > Power Level, select High Power or Low Power, and then press the OK/Menu key.
8.1.2.2 VOX
The Voice Operated Transmit (VOX) feature allows the voice to trigger transmission. When the voice detected by
the microphone reaches the value to trigger transmission, the radio automatically transmits the voice without the
PTT key pressed.
Go to Call Settings > VOX, and then press the OK/Menu key to enable the feature.
Select External/Internal, and then adjust the microphone transmission sensitivity.
A smaller number of a level represents higher sensitivity.
8.1.2.3 Talker Alias
With the Talker Alias feature enabled by your dealer, go to Call Settings > TalkingAlias, and then do either of the
following:
Send Alias
This feature allows you to send the radio alias during a call, so that the called party can identify the calling
party by the alias.
Select Send Alias, and then press the OK/Menu key to enable or disable the feature.
Auto Add Contacts
If both the calling party and the called party enable the Auto Add Contacts and Send Alias features, the called
party automatically adds the calling party to the contact list when receiving the call.
In conventional mode, this feature is enabled by your dealer. In trunking mode, you can select Auto Add
Contact, and then press the OK/Menu key to enable or disable the feature.
8.1.2.4 Talk Around (Conventional Only)
The Talk Around feature allows you to continue communication in direct mode when the repeater malfunctions or
the radio is out of the repeater's coverage.
Go to Call Settings > Talk Around, and then press the OK/Menu key to enable or disable the feature.
To Next Page
Loading...
Need help?
General
