1. Loosen the screw fixing the Micro SD card
cover, remove the cover, and then place the
card in the holder correctly as shown below.
2. Replace the cover and tighten the screw as
shown below.
Attaching the Battery
· Upon power-on, the radio automatically
checks if the battery is approved by Hytera
and gives a corresponding indication.
· Using an unapproved battery disables the
Battery Save feature, makes the battery
power indication inaccurate, and reduces
the radio performance.
Attaching the Belt Clip
1. Unfasten the two screws on the back of the
radio.
2. Align the screw holes on the belt clip with those
on the back of the radio, as shown below.
3. Tighten the screws.
Attaching the Accessories
For optimal waterproof and dustproof
performance:
· Do not scrape the silicone waterproof pad
surrounding the screw hold of the accessory
connector.
· Do close the accessory connector cover and
fasten the screw after removing the
accessory.
5
To Next Page
Loading...
