Compliance with RF Exposure
Standards
Hytera's portable radio complies with the following
RF energy exposure standards and guidelines:
· United States Federal Communications
Commission, Code of Federal Regulations; 47 CFR
§ 1.1307, 1.1310 and 2.1093.
· American National Standards Institute (ANSI) /
Institute of Electrical and Electronic Engineers
(IEEE) C95. 1:2005; Canada RSS102 Issue 5
March 2015.
· Institute of Electrical and Electronic Engineers
(IEEE) C95.1:2005 Edition
RF Exposure Compliance and
Control Guidelines and Operating
Instructions
To control your exposure and ensure compliance with
the occupational/controlled environment exposure
limits always adhere to the following procedures.
Guidelines:
· Do not remove the RF Exposure Label from the
device.
· User awareness instructions should accompany
device when transferred to other users.
· Do not use this device if the operational
requirements described herein are not met.
Operating Instructions:
· Transmit no more than the rated duty factor of
50% of the time. To transmit (talk), push the Push-
To-Talk (PTT) button. To receive calls, release
the PTT button. Transmitting 50% of the time, or
less, is important because the radio generates
measurable RF energy only when transmitting (in
terms of measuring for standards compliance).
· Keep the radio unit at least 2.5 cm away from the
face. Keeping the radio at the proper distance is
important as RF exposure decreases with distance
from the antenna. The antenna should be kept
away from the face and eyes.
· When worn on the body, always place the radio in
a Hytera-approved holder, holster, case, or body
harness or by use of the correct clip for this
product. Use of non-approved accessories may
result in exposure levels which exceed the FCC's
occupational/controlled environmental RF
exposure limits.
· Use of non-approved antennas, batteries, and
accessories causes the radio to exceed the FCC
RF exposure guidelines.
· Contact your local dealer for the product's optional
accessories.
IC Statement
The device has been tested and complies with SAR
limits, users can obtain Canadian information on RF
exposure and compliance
Après examen de ce matériel aux conformité aux
limites DAS et/ou aux limites d’intensité de champ RF,
les utilisateurs peuvent sur l’exposition aux
radiofréquences et la conformité and compliance
d’acquérir les informations correspondantes
This device complies with Industry Canada license-
exempt RSS standard(s). Operation is subject to the
following two conditions:
· This device may not cause harmful interference.
To Next Page
Loading...
