You can set
the following parameters of
the Smart MDM accounts:
Self-upgrade mode: In this mode, the product periodically queries whether a
firmware upgrade is available on the Smart MDM. If yes, you will be reminded
to upgrade the firmware.
Server address: address of the server where the upgrade firmware is stored. You
can
enter
the domain name, or the address in the format of "IP address of the
server: port number
"
.
Strong control mode: In the mode, you can manage the product, and change the
Smart MDM address on the product through the Smart MDM. In addition, self-
upgrade is unavailable.
Server address: address of the Smart MDM server with the format of "IP
address of the Smart MDM server: port number".
The parameter of the DEM account is described as follows:
Report address: Address of the DEM server with the format of "IP address of the
DEM server: port number".
You can view the device name, device ID, software version, serial number (SN), international mobile
equipment identifier (IMEI), mobile equipment identifier (MEID), storage capacity (total space and
available space), and certifications.
To Next Page
Loading...
