Need help?Do you have a question about the Hyundai N100 and is the answer not in the manual?
Details the RS485 circuit in the N100 Inverter and its ability to control multiple slave inverters from a master device.
Specifies the RJ45 pin assignments and their corresponding signal descriptions for the RS485 serial communication cable.
Presents a wiring diagram for connecting a PC/PLC to the inverter via RS485, with a note on direct PLC RS485 port usage.
Lists technical parameters for RS485, including baud rate, data bits, parity, stop bits, and connection types.
Outlines the necessary inverter settings for RS485 communication, such as communication number and operational modes.
Illustrates the data flow and timing between master and inverter, covering frame start and completion recognition.
Explains the ModBus protocol used for RS485 communication, operating on a Query-Response cycle controlled by the master.
Defines the structure of transmit and response frames for reading inverter parameters via RS485 communication.
Details the structure of transmit and response frames used for setting inverter parameters via RS485 communication.
Provides examples of reading inverter data, including specific function codes for output frequency and acceleration time.
Demonstrates setting inverter parameters like acceleration and deceleration times using RS485 communication.
Illustrates frequency command transmission and response for specific values like 60Hz and 50Hz.
Shows transmit and response data for RUN commands, including Forward, Reverse, and STOP operations.
To Next Page
General