Why does my Hyundai Inverter show a Motor Overload error?
A Motor Overload error on your Hyundai Inverter indicates that the motor's FLA (Full Load Amp) rating has been exceeded. The internal electronic thermal overload protection circuit activates to protect the motor.
What causes an Overvoltage error on a Hyundai N700E Inverter?
An Overvoltage error on your Hyundai Inverter occurs if the regenerative energy from the motor or the main power supply voltage exceeds the DC link specification. When this happens, the protective circuit activates to shut off the VFD output.
What does a Output Short Circuit error mean on my Hyundai Inverter?
An Output Short Circuit error on your Hyundai Inverter indicates that excessive current is detected at the output terminals of the VFD.
What does Communication Error mean on Hyundai N700E Inverter?
A Communication Error on your Hyundai Inverter indicates a communication problem between the inverter and its operator for all optional cards. This error can also occur if the Reset signal persists for more than 4 seconds or if an invalid parameter address is read.
What does Under voltage mean on Hyundai Inverter?
An Under voltage error on your Hyundai Inverter means that the input voltage has dropped below the low voltage detection level. This can prevent the control circuit from functioning correctly.
What does USP Error mean on Hyundai N700E?
A USP Error on your Hyundai Inverter is shown when the power is turned on while the Inverter is in RUN state. This is enabled when the USP function is selected.
What does EEPROM error mean on Hyundai Inverter?
An EEPROM error on your Hyundai Inverter indicates that the EEPROM within the VFD has encountered an error, which results in the VFD output being shut off.
What does External Interlock 1 error mean on Hyundai N700E Inverter?
An External Interlock 1 error on your Hyundai Inverter means that an Intelligent Input terminal, programmed to monitor an external condition, has gone low (false).
What does External Interlock 2 error mean on Hyundai N700E?
An External Interlock 2 error on your Hyundai Inverter means that an Intelligent Input terminal, programmed to monitor an external condition, has gone low (false).
What does External Interlock 3 error mean on Hyundai N700E?
An External Interlock 3 error on your Hyundai Inverter means that an Intelligent Input terminal, programmed to monitor an external condition, has gone low (false).
To Next Page
General