I LOCK IT GPS - Page 21

40
41
START SET-UP MODE WITH KEY FOB
+
To put your I LOCK IT GPS into setup mode using a connected
key fob
+
, follow these steps:
I. Make sure that the key fob
+
is connected to your
I LOCK IT GPS.
II. Press and hold the key fob
+
button for at least 6 seconds
and then release the button.
I LOCK IT GPS enters set-up mode.
START SET-UP MODE WITH COLOR CODE
If you have lost your paired smartphone or key fob
+
,
the set-up mode can also be started using the color code
configured during initial set-up.
I. Open your I LOCK IT GPS by entering your personal
color code, which you configured during the initial
set-up of the I LOCK IT app.
OPERATION
The color code can only be entered if no
Bluetooth connection to your I LOCK IT GPS is
active. The following steps will not work with
a created color code for sharing.
II. Wait until I LOCK IT GPS is open and the button lights green.
III. Press and hold the I LOCK IT GPS button until it lights up blue.
When the button is released, I LOCK IT GPS
enters the set-up mode.
Our I LOCK IT Channel on
www.youtube.de presents a video
on the subject of color codes.
www.youtube.com/ILOCKIT-bike
PAIR NEW SMARTPHONE
I. Open the I LOCK IT app on your new smartphone.
II. Follow the instructions in the I LOCK IT app.
III. As soon as the I LOCK IT GPS button lights up blue for
5 seconds and the app confirms successful pairing, the
new smartphone is also connected to I LOCK IT.
OPERATION