I LOCK IT GPS - Restoring the Factory State; 6 Further Information; Optical Signals

54
55
5.4. RESTORING THE FACTORY STATE
To restore your I LOCK IT GPS to factory default settings,
follow these steps:
I. Open the I LOCK IT app and make sure the connection to
your I LOCK IT GPS is active.
II. Open the "Settings“ menu and enter the "My I LOCK IT“
submenu.
III. Press the button "Reset lock“.
IV. Confirm the warning message. Your I LOCK IT GPS is now
reset to factory state.
• The factory state of I LOCK IT GPS will reset
all settings to default, the color code and all
connected devices will be deleted.
• After resetting, the phone must be paired with
I LOCK IT GPS again.
• The key fob
+
must also be reset to the
factory setting and then it must be paired with
I LOCK IT GPS again.
6. FURTHER INFORMATION
6.1. OPTICAL SIGNALS
The I LOCK IT GPS button serves as a visual indicator, which
can show different states. The following signals are displayed.
BLUE LED FLASHES
• If the blue LED flashes continuously, I LOCK IT GPS in setup
mode: A new connection to your I LOCK IT GPS can be
established.
• When flashing blue 3 times, the connection to your
smartphone or the key fob
+
is lost.
BLUE LED LIGHTS UP
• A new connection was successfully established.
• The existing connection was restored after a connection
termination.
GREEN LED LIGHTS UP
• During opening procedure: I LOCK IT GPS was
successfully opened.
FURTHER INFORMATIONMAINTENANCE AND CARE