Caution
The air handler must be installed so that electrical components are not exposed to
water during operation.
Note
All wiring on IBC air handlers must adhere to the National Electrical Code and/or local
regulations.
Note
All appliances conform to CSA C22.2 NO. 236-15 and UL 1995 Stds. Water coil
conforms to NSF / ANSI Std. 372.
Important safety instructions
Failure to read and comply with all instructions and applicable national and local codes may result
in hazardous conditions that could result in property damage and injury to occupants, and in
extreme cases to death. Keep instructions near the air handling appliance for future reference.
When using electrical appliances, follow safety precautions to reduce the risk of fire, electric
shock, or injury to persons, including:
Install or locate the air handling appliance only in accordance with the provided installation
instructions.
Use the air handling appliance only for its intended use as described in this manual.
Do not operate the air handling appliance if it is not working properly, or if it has been
damaged or dropped.
Installation, start-up and servicing of IBC's air handling appliances must be done with care
and attention, and should only be performed by competent, qualified, licensed and trained
plumbing and heating technicians. Contact your nearest authorized service facility for
examination, repair, or adjustment.
If subjected to flooding, the appliance must be replaced.
Section: Safety information