IBERITAL DE RECAMBIOS, S.A.
1.6.- DAILY CLEANING OPERATIONS
Cleaning the spray filters
Every evening or at least once a day it is necessary to carry out the following:
Rinse the filters and filter bowls in hot water every evening or at least once during the day. Further still
allow them to soak overnight in water which is initially hot in order to dissolve the fat deposited by the
coffee.
Clean the spray jets and gaskets of the lower feed unit as follows:
- press the coffee feed button.
- place the filter holder (23) or (25), fitted with the cleaning blind filter (26), into the feed unit.
- Grip the filter holder at the end of the handle; rotate the filter holder to and through in order to allow
the hot water to have a rinse effect on the unit.
- Clean the gasket of the lower feed unit group using a soft cloth or a sponge.
- Clean the steam jets and cappuccinatore using URNEX milk frothier and steam jets cleaner.
Cleaning the groups
a) Substitute the normal filter (22) or (24) with the cleaning filter (blind) (26).
b) Place a couple of spoonfuls of detergent (bags of 20 gr. - Code 3852 URNEX – NSF approved)
into the cleaning filter (blind) (26).
c) Place the filter holder into the feed unit.
d) Switch on the unit and leave it working for several seconds (15-20").
e) Stop the unit by pressing the feed button a second time; during the decompression of the unit the
hot water and detergent will clean the feed group.
f) Repeat point (e) several times.
g) Rinse the unit and without the filter holder into the feed unit push any feed button to clean any
residual detergent.
Cleaning the outer shell of the machine
The external paneling of the machine should be cleaned with hot (not boiling) soapy
water and then rinsed thoroughly, using a soft cloth or a sponge. Do not use abrasive substances as
these could scratch the surface of the panels.
Página 11 de 30 MANUAL NEW IBERITALINGLES
11/05/2007
To Next Page
Loading...
