Iberital 2 Groups - Preparation and Turn On Procedure; Programming Dosing Controls

IBERITAL DE RECAMBIOS, S.A.
1.2.- PREPARATION - TURN ON
a) Turn on the water stopcock (20) at the mains.
b) Switch on the power at the mains (12).
c) Turn the switch (13) to the position 1 and wait for the automatic water level control
to finish filling up the boiler.
Only for 3 groups espresso machine: In case the automatic fill up control would stop and the
lights of the push buttons would flicker, turn the switch (13) off and immediately turn the switch
(13) on to the position 1 another time, and wait for the automatic water
control to finish filling up the boiler.
d) Turn the switch (13) to the position 2.
Wait for the operating pressure, indicated on the pressure gauge (11) (0,8-1bar). The green light (15)
will turn off .
The machine is heated by electricity.
1.3.- PROGRAMING THE DOSE
I. TOUCH PATH PERFORMANCE
DOSING TOUCH PATH
1 LONG
COFFEES
2 SHORT
COFFEES
1 LONG
COFFEE
1 SHORT
COFFEE
HOT WATER
SWITCH
CONTINUOUS
Important: The two touch path have electric signal with any of the two positions (1 and 2) of the On-
Off switch.
In the position 1, the automatic fill up is working, but the touch path cannot make any coffee
(erogation).
Página 7 de 30 MANUAL NEW IBERITALINGLES
11/05/2007