IBIX 25 - Troubleshooting

42
7.5 TROUBLESHOOTING
FAULT
POSSIBLE CAUSE
SOLUTION
No air delivery from the
nozzle
Compressor disconnected or turned
off
Pressure reducer control turned fully
off
Nozzle obstructed by foreign matter
Blasting material particle size too
coarse
Connect the compressor to the IBIX
machine and turn it on
Turn on the control to the required
setting
Clean nozzle
Replace nozzle
The nozzle delivers air only
without any blasting material
The machine is empty: no more
blasting material in the tank
The adjustment valve on the lower
plate is jammed
The blasting material flow adjustment
screw is turned off
Blasting material particle size too
coarse
The blasting material is damp or
contains foreign matters
Full the tank with blasting material
Remove the blast adjustment screw
and clean it
Turn the adjustment screw until
reaching the required amount of
blasting material
Replace nozzle
Empty and clean the machine and fill
it with clean, dry blasting material
Discontinuous blasting material
flow
Blasting material flow adjustment
screw open too wide
Turn off the adjustment screw until
reaching the required amount of
blasting material
The required cleaning results
cannot be obtained
Incorrect air/blasting material mix
Blasting material hose punctured or
cracked
Unsuitable nozzle for the chosen
application
Unsuitable blasting material or particle
size for the chosen application
Adjust the pressure reducer to the
required pressure
Replace hose
Replace nozzle with a suitable one
Replace the blasting material used
with another material suitable for the
required results
Gun air leaking
The air control hoses on the start/stop
control have been exchanged
Disconnect the air control hoses and
exchange their positions
Tank overpressure (> 8.5 bars - > 123
psi)
Malfunction of the safety valve
Replace the safety valve (see also par.
3.2)