Diagnosing and recovering from problems
10-19
1783
Secondary slave hard disk fail 1. Load the default settings in Setup.
2. Check the IDE drive jumper.
3. Check the power to the IDE drive.
4. Check the IDE cable/connection.
5. Check the IDE drive.
8602
PS/2 Mouse error OR no PS/2
mouse present
1. Determine if the mouse is connected
properly and is defined correctly in
BIOS Setup.
Table 4: Error codes and messages (Continued)
Error codes Error messages Corrective actions
Note:
If any of the errors persist after performing the listed corrective actions, see “Chapter
2. HelpWare support and services” for information on obtaining service.
To Next Page
Loading...
Need help?
General