IBM 2196

viii IBM Personal Computer User Guide
Adding and removing adapter cards and drives .....................................8-1
Resolving conflicts with installed adapter cards ............................................8-2
Setting modem card configurations ......................................................8-2
Working with the hardware in the system unit ...............................................8-3
Adding and removing adapter cards .............................................................8-4
Installing adapter cards ........................................................................8-4
Removing adapter cards ......................................................................8-5
Removing and adding drives .........................................................................8-6
Identifying signal cable connectors .......................................................8-6
Removing the CD-ROM drive ...............................................................8-11
Removing the hard disk drive ...............................................................8-12
Updating the CMOS settings in Setup ...........................................................8-13
For adapter cards .................................................................................8-13
For Drives .............................................................................................8-13
Adding and replacing system board components ..................................9-1
Identifying system board parts (machine type 2196) .....................................9-2
Locating system board jumpers and connectors (machine type 2196) .........9-4
Identifying system board parts (machine type 2197 and 6344) .....................9-5
Locating system board jumpers and connectors (machine type 2197
and 6344) ......................................................................................................9-7
Card connector and jumper information ........................................................9-8
Identifying adapter card connectors .....................................................9-8
Setting a jumper ...................................................................................9-8
Upgrading the system memory .....................................................................9-9
Installing memory modules ...................................................................9-9
Removing memory modules .................................................................9-10
Verifying the system memory ...............................................................9-10
Replacing the system battery ........................................................................9-11
Updating the CMOS settings in Setup ...........................................................9-13
Part 5. Troubleshooting
Diagnosing and recovering from problems .............................................10-1
Before you panic: some simple fixes .............................................................10-2