Test 8000
1 Check your wall outlet for proper operation (use
a working lamp).
2 Verify that your printer cable is properly
connected
to
the printer
and
the system unit.
Did you find any problem while doing the above
step?
NO
-
Go
to
the next step.
YES - Correct the problem and perform the
system diagnostic tests again.
3
Set the Power switches
on
the printer and
system unit
to
Off.
(If
an
expansion unit
is
attached, also set its Power switch
to
Off.)
4
Disconnect the printer cable.
January
1984
Test 8000-1
To Next Page
Loading...
