Figure 128. Replacing the air baffle in a stand-alone system
Preparing the 9009-41A, 9009-41G, 9009-42A, 9009-42G, or 9223-42H system for
operation after removing and replacing a drive backplane power cable
To prepare the system for operation after removing and replacing a drive backplane power cable,
complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. Replace the service access cover.
For a rack-mounted system, complete the following steps. Refer to Figure 129 on page 144
.
a. Slide the cover (A) onto the system unit.
b. Close the release latch (B) by pushing it in the direction shown.
Drive backplane cables in the 9009-41A, 9009-41G, 9009-42A, 9009-42G, or 9223-42H
143
To Next Page
Loading...
