Figure 139. Removing the service access cover
Removing the drive backplane signal cable from the 9009-41A, 9009-41G, 9009-42A,
9009-42G, or 9223-42H system
To remove the drive backplane signal cable from the system, complete the steps in this procedure.
Procedure
1. Ensure that you have the electrostatic discharge (ESD) wrist strap on and that the ESD clip is plugged
into a ground jack or connected to an unpainted metal surface. If not, do so now.
2. For a rack-mounted system, lift the air baffle (A) straight up as shown in Figure 140 on page 158
.
For a stand-alone system, remove the air baffle (A) straight out as shown in Figure 141 on page 159.
Place the air baffle upside down on a clean area.
Drive backplane cables in the 9009-41A, 9009-41G, 9009-42A, 9009-42G, or 9223-42H
157
To Next Page
Loading...
