Check Procedures 41
1780
IDE Primary Channel Master Drive Error
1781
IDE Primary Channel Slave Drive Error
1782
IDE Secondary Channel Master Drive
Error
1783
IDE Secondary Channel Slave Drive Error
Enter BIOS Setup and load the default
settings.
Check IDE drive jumper. See “3.5-In. Hard
Disk Drive Jumper Settings” on page 161.
IDE hard disk drive power.
IDE hard disk drive cable/connection.
IDE hard disk drive.
1780
IDE Primary Channel Master Drive
Changed
1781
IDE Primary Channel Slave Drive
Changed
1782
IDE Secondary Channel Master Drive
Changed
1783
IDE Secondary Channel Slave Drive
Changed
Enter BIOS Setup and load the default
settings.
IDE hard disk drive cable/connection.
1800
IRQ Setting Error
1801
Expansion ROM Allocation Failed
1802
I/O Resource Conflict(s)
1803
Memory Resource Conflict(s)
Load default settings in Setup.
Enter BIOS Setup and set the Reset
Resource Assignments parameter to Yes,
then reboot the system. “PnP/PCI
Options” on page 25.
Remove all adapter cards that are NOT
factory-installed, then reboot the system
Table 2-1 POST Error Codes and Messages List
NOTE:
To diagnose a problem, first find the BIOS error messages or codes in left
column. If directed to a check procedure, replace the FRU indicated in the check
procedure. If no check procedure is indicated, the first Action/FRU listed in right
column is the most likely cause.
BIOS Error Codes, Messages Action/FRU
To Next Page
Loading...
