A value of 0 in the following parameters indicate that those are Target specific.
Alternate Sectors per Zone
Alternate Tracks per Zone
Alternate Tracks per Logical Unit
Sectors per Track specifies the number of physical sectors within each track. This field is a function of the
active notch.
Track Skew Factor indicates the number of physical sectors between the last block of one track and the first
block on the next sequential track of the same cylinder. This field is a function of the active notch.
Cylinder Skew Factor indicates the number of physical sectors between the last block of one cylinder and the
first block on the next sequential cylinder. This field is a function of the active notch.
SSEC = Zero indicates that the file does not support soft sector formatting.
HSEC = One indicates that the file supports hard sector formatting.
RMB = Zero indicates that the media does not support removable. Fixed Disk.
SURF = Zero indicates that progressive address are assigned to all logical blocks a cylinder prior to allo-
cating address within the next cylinder.
SCSI COMMAND SET 103
To Next Page
Loading...
