ECMA is set to zero to indicate that this product does not claim compliance to the European Computer
Manufacturers Association (ECMA) version of SCSI (ECMA-111).
ANSI indicates the level of the ANSI standard that is supported by the product. The file supports ANSI
SCSI version 2.
RDF is set to two to indicate that the Inquiry Data Format as specified in ANSI SCSI version 2 is
supported by the file.
Additional Length indicates the number of bytes of inquiry information that follows.
REL_A is set to zero to indicate that the file does not support 'Relative Address Mode'.
Wb_32 is set to zero to indicate that the file does not support 32-bit wide data transfers.
Wb_16 is set to one to indicate that the file supports 16-bit wide data transfers. Wb_16 is set to zero to
indicate that the file does not support 16-bit wide data transfers.
Sync is set to one to indicate that the file supports synchronous data transfer.
Link is set to one to indicate that the file supports linked commands.
TTD is set to zero to indicate that the file does not support the CONTINUE I/O PROCESS and
TARGET TRANSFER DISABLE message for this logical unit.
CmdQu is set to one to indicate that the file supports command queuing. CmdQu is set to zero to
indicate that the file does not support command queuing.
SftRe is set to zero to indicate that the target supports Hard Reset only.
Vendor ID is 'IBM' padded with ASCII blanks.
Product ID is specified in ASCII character.
Figure 62. Product ID vs. Formatted Capacity
Product Revision Level indicates the level of microcode. It indicates RAM microcode level.
Unit Serial Number contains the file serial number.
Product ID DDRS-34560 DDRS-39130 DDRS-34560W DDRS-39130W
Maximum LBA 8924999 17849999 8924999 17849999
Number of Blocks 8925000 17850000 8925000 17850000
SCSI COMMAND SET 73
To Next Page
Loading...
