IBM FlashSystem 710 Product Guide

IBM FlashSystem 710 and IBM FlashSystem 810 12
Controlling the FlashSystem unit:
z
Powering on/off
z
Uptading firmware
z
Configuring network settings
z
Changing storage mode (JBOF or RAID 0)
z
Creating logical volumes (LUNs)
z
Configuring LUN masking
z
Configuring host interfaces
z
Configuring user security
z
Setting the date and time
z
Supported platforms
IBM FlashSystem systems support a wide range of operating systems (Windows Server 2003 and 2008,
Linux, and IBM AIX®), hardware platforms (IBM System x
®, IBM Power Systems, and x86 servers not
from IBM), HBAs, and SAN fabrics. For specific information, see the System Storage Interoperation
Center (SSIC): http://ibm.com/systems/support/storage/ssic
Physical and electrical specifications
FlashSystem 710 and FlashSystem 810 have the following physical, electrical, and environmental
specifications:
Dimensions and weight (approximate):
z
Height: 44 mm (1.7 in.)
z
Width: 432 mm (17.0 in)
z
Depth: 569 mm (22.4 in)
z
Weight: 13.6 kg (30 lb)
z
Operating environment:
z
Temperature:
z
Operating: 10 - 35 degrees C (50 - 95 degrees F) at 30.5 m below to 3000 m above sea level
z
(100 ft below to 9,840 ft above sea level)
Non-operating: -10 - 50 degrees C (14 - 125 degrees F)
z
Humidity:
z
Operating: 20% - 80%
z
Non-operating: 10% - 90%
z
Supported electrical input:
z
100 - 240 (nominal) V ac; 50-60 Hz
z
Input electrical power (approximately):
z
FlashSystem 710: 280 watts
z
FlashSystem 810: 350 watts
z
BTU output:
z
FlashSystem 710: 955 BTU/hr
z
FlashSystem 810: 1194 BTU/hr
z
Acoustical:
z
Noise emission: 8.0 bels
z

IBM FlashSystem 710 Specifications

General

Brand	IBM
Model	FlashSystem 710
Category	Storage
Language	English